Q&A Forum

@donperry Great. Both of these options will work. I assume the web server a bit slower than the serial, or is it not noticeable? What is the update fr...

@bigm Good! I think the best would be if Knock Monitor Pro can run in parallel with YourDyno and output the data we need. The plugin and Knock Monitor...

@choyrowel just connect it to the CAN bus and configure the CAN bus data channels as indicated here: CanBus Support | Speeduino Manual

If anyone wants to create this plugin then I can help. It is a pity that the Knock Monitor Pro does not have a CAN bus output, then it could be rea...

Folks, YourDyno software version 3.3.82 was released today. Changes since 3.3.81: Ability to use a physical button to start/stop runs. See O...

@xtcund download the Unified Remote app on your phone and install the server on the PC. This gives you access to the hotkeys from your phone. With the...

Hi, In general for EMI reduction you can Make sure the dyno chassis, dyno box and the engine/car are grounded Move sensors, cables and electro...

You use a KmTronic USB relay. These can be controlled from YourDyno, either with a button press or a data channel threshold. See USB Relay Controller ...

See attached picture. If you mean the Run menu option is grayed out, then it means you have the Run window open already, so you just need to switch...

Click Save and Restart

Folks, all settings are transferred if you use the Options->Backup options to file and Restore options to file. However, you MUST have the same plu...

Folks, YourDyno software version 3.3.81 (beta) was released today. Changes: A number of improvements to the gauge layout functionality Save...

Hi, the Smarttach has a digital output too that can be connected to RPM2 or Dig In1/2. You could also use the Analog out. Then you connect it to an...

Do you mean to read the duty cycle of the injector pulses? That is not possible today.

You need to change the Aux setup. 0V = 10 AFR and 5V = 20 AFR. So you set it like the attached picture.  afr.jpg