Q&A Forum
Notifications
Clear all
Topic starter
I need to replace a Pc on my dyno. Once I have loaded the your dyno software is there a file I can transfer from the old pc to the new pc that would have the old dyno setup? ie calibration and printer page setup
Posted : 20/09/2023 10:14 pm
Yes, go to Options->Backup options to file on your old PC. Then on your new PC you do Options->Restore options from file
Posted : 20/09/2023 11:15 pm
I am in a similar situation but it seems not all options get transferred, for example can devices and math channels arent.
is the dyno loadcell linearisation/calibration also included in the stored options file?
Posted : 21/04/2024 9:50 pm