Q&A Forum

Andrew
@andrew
Member
Topics: 9 / Replies: 21
Reply
RE: Inertia dyno high readings

So, with the Moi re visited, my old notes checked I am locking in my inertia value as correct. Which only leaves RPM setup. The now removed Performanc...

1 year ago
Reply
RE: Inertia dyno high readings

Thanks for the reply. roller rpm is around 800, I have a 40 tooth wheel which i think is ok. The roller rpm data is stable. I have used Dtec, performa...

1 year ago
Topic
Reply
RE: Flow bench

@rub87 Here is a bench I built which I am considering building a your dyno logger to replace what I have.

4 years ago
Reply
RE: Flow bench

I was thinking a dedicated box, your existing box with two pressure sensors built in and another to measure velocity. Yes an air flow meter for low fl...

4 years ago
Topic
4 years ago
Replies: 6
Views: 7880
Topic
6 years ago
Replies: 2
Views: 6416
Topic
6 years ago
Replies: 0
Views: 6254
Reply
RE: CANTOOL not loading

Hi yes that's it. Just go to Microsoft site and download.

6 years ago
Reply
RE: list of variables during rpm? request

Great idea, handy to have a data sheet like that to analyze after runs. Should be quite doable, all the data is there and available, just needs a spre...

6 years ago
Reply
RE: Latest software version

@admin Thanks for looking into this, I will do my best to test this today with the changes you've suggested.

7 years ago
Reply
RE: Latest software version

@aslot Hello,For what its worth I too am having issues with my RPM1 disappearing after a short time. I have only one RPM input, a GT101 sensor (engin...

7 years ago
Reply
RE: Scratch built water brake

I understand what you are saying and it may be valid in your experience but the issue may be specific to your dyno setup. Early Superflows did have th...

7 years ago
Page 1 / 2