Q&A Forum

OSI
@osi
Member
Topics: 10 / Replies: 46
Reply
RE: New Software features

Anyone having printing issues? Now printer is only printing the run info on the bottom of the graph. I can open a previous run from the file and it pr...

3 months ago
Reply
RE: Latest software version

@admin I finally figured it out. computer was showing it as com port 4. I switched setting to port 7 I guess something else was wanting port 4???...

4 months ago
Reply
RE: Can not get v4 to work on new software stuck with 3.2.162.00

Jostein you are the greatest!!! If i was you, i’d be cussing me out! So simple to fix but the wording be so hard for me. Again , MANY THANKS!!!! ...

5 months ago
Reply
RE: Can not get v4 to work on new software stuck with 3.2.162.00

@admin the autoSetGearRatio is already set to false. I tried "True" which didnt work either . I also sent you a config file on friday Again dyno ...

5 months ago
Reply
RE: Engine RPM

I had better luck hooking to the negative side of the coil

1 year ago
Reply
RE: Latest software version

@admin THANK YOU FOR ALL YOU DO!!! When we slow down I'll try the new version. still running an older version and doing good. Enjoyed talking wit...

1 year ago
Reply
RE: retarder not retarding with new software

Best i can tell rpm1 and load cell is correct. Should the option"brake linearization" be enabled?

1 year ago
Reply
RE: new software issue

ok i have rpm1 as the roller rpm 30 tooth rpm2 setup as motor rpm .5 setting like i had the older software setup when i do gear ratio setup. in ol...

1 year ago
Reply
RE:another new software issue

I had to switch back to version 3.2.162.0 I could not get the retarder to retard on the new software. i have attached my config file for the new ve...

1 year ago
Reply
RE: new software issue

I understand the name but under options i have aux3 "TPS" now named, setup as 0 volts equals 0 percent 5 volts equals 100 percent. most tps sensors ...

1 year ago
Topic
Page 1 / 4
Select your currency