@admin THANK YOU FOR ALL YOU DO!!! When we slow down I'll try the new version. still running an older version and doing good. Enjoyed talking wit...
Best i can tell rpm1 and load cell is correct. Should the option"brake linearization" be enabled?
ok i have rpm1 as the roller rpm 30 tooth rpm2 setup as motor rpm .5 setting like i had the older software setup when i do gear ratio setup. in ol...
I had to switch back to version 3.2.162.0 I could not get the retarder to retard on the new software. i have attached my config file for the new ve...
I understand the name but under options i have aux3 "TPS" now named, setup as 0 volts equals 0 percent 5 volts equals 100 percent. most tps sensors ...
thank you! your the greatest!
Is your drum rpm staying the same when you go wide open? If so you have tire slip or tire diameter changing (to low air pressure possibly)
Sorry for the double. i try not to have the run open any longer than I have to. It can screw up my first pull. wish the hot key for load and unload...
Thank you again for helping us out. I know we always keep asking for more. And you give us more thank you. On your load unload option is there anyway ...
I'm starting to get interest in dynoing side by sides with variable speed trans which means as soon as you go wide open rpm goes to one rpm and stays ...
I think I found a couple bugs? Or I'm doing something wrong. I was playing around with KP KI KD settings and saved them. Had a previous customer c...
@walter it’s under “print page setup”
