Q&A Forum

I thought it might be possible to disable them in hotkey menu, just I'm not in front of the PC now to check. Thanks

Hi Jostein, is it possible to deactivate those 100% lock hotkeys? I would prefer not to have them because a eddy current at continuous 100% will o...

Just started using the latest from .129, I see that it picks my system language for column description under the main screen and it doesn't change eve...

@vishara-jyasekara you hav to use an HALL effect sensor for RPM measurement, so you can change the sensor, of get a small board that is used laso with...

@chipg1956 I've used a S type load cell because I wanted to be able to run vehicles in both direction, plus the dyno was rated for 260kW in MAHA's dat...

@chipg1956 I've used a S type load cell because I wanted to be able to run vehicles in both direction, plus the dyno was rated for 260kW in MAHA's dat...

@vishara-jyasekara Yes I've converted it with YourDyno instrument and PS, and I've sold the old control with all the boards to another LPS2000 owner t...

@kessel-one I was about to pull very same request. I run the dyno in both direction, so I invert calibration quite often. Plus I use auto MOI calcul...

OK my fault, there was a slight RPM drift in some runs at high rpm and it wasn't actually catch the "end RPM" value.With a MOI of around 10 it's still...

I've tried to run the MOI measurement in one run (power sweep), but at the end it gave a warn pop-up, saying that it didn't reached the end rpm thresh...

OK, I'll machine one of them to make a 20 teeth wheel from it, with dimensions suggested in "RPM wheel" wiki area

Wheels are 100 teeth

RPM sensors (there are two, one per roller axle ... ) Most def are VR, two wire....  IMG_20210201_094046.jpg

Classic MAHA bar type load cell  MVIMG_20210201_091606.jpg