Q&A Forum
All the can bus configurations are stored here: C:\ProgramData\YourDynoPlugins\ControlCAN.dll.json Settings for the old version are preserved when u...
You mean the water brake valve zero position sensor? It can be connected to RPM2, 3 or 4 if Freq 1 and 2 are used.
Hi, Open the box, move the pullup jumper.
Hi folks, A new minor release 3.3.74 (beta) with a few cleanups/changes: Support for 2 water brake valves that move in parallel. This is used f...
There are manuals onbut not a step by step guide as there are so many different dyno types and engine types. We can login and help you set it up th...
OK, disconnect and connect power again. If you have connection again then click "Jump to bootloader". If that does not work, then your usb extension...
Does the download start? What is the error message?
That can be used as information to define the channels. Let me know if you need any help and i can do it. Message me directly on Whatsapp: +47 4840 12...
Hi, By far the easiest way is to ask EcuMaster for the CAN bus .dbc file. This can be read into YourDyno, and all channels are automatically configu...
Hi, this is likely because the Moment of Inertia is wrong. With different gearing, the acceleration on the brake is different. You will likely see the...
All the well-known brands are good, Telma, Frenelsa, Klam etc. The KAS series from Keao Retarder in China is apparently not fully at the same level, b...
That's a flow meter, right? There are a few different types. Do you have the spec for it? If this is a FloScan, then it needs 12V and the signal conne...
No, amplified load cells with 0-5V output cannot be used as the regular YourDyno load cell. You can likely remove the load cell amplifier though so yo...
Hi, The best way is to read the real engine RPM either via RPM pickup or CAN bus (OBD2 is too slow) and then create a math channel called Slip which...
I don't understand fully. Give me a call on +47 4840 1279 (whatsapp or phone) and I will take a look. Install Ultraviewer first so I can login to your...