Q&A Forum
That is configured in Options->CAN Bus->CAN input channels. If you configure it by hand you need to click the View/Hide all fields. You will n...
@loonytu Weather station goes into the plug called Env Sensors (environmental sensors)
Hi, this may well work, no harm in trying. The signal from the Motec needs to be fairly strong, since the RPM signal has a 500Ohm pullup.
Hi, This may happen if you did a manual copying of plugins files, or if they somehow were not updated. Delete the .dlls that don't work in the C:\Pr...
Hi, Apologies for missing your question. Yes for sure we can provide an upgraded data acquisition system. You need: 1 YourDyno Ultimate or Y...
Yes, the original Superflow RPM sensor is compatible with the Ultimate. There are two wires and shield. Shield goes to shield and the other two to t...
Hi, is that a air operated brake? Post a few pictures.
Hey tuners! New YourDyno software version today: 3.3.71 (beta) Changes: The RPM test range (start RPM to end RPM) is now indicated in the Engi...
Hi, Attached is the adaptor plate for running a YourDyno valve with a Superflow brake. Superflow-adapter.PDF
With all the manual stuff you did in the registry and the files, the install may be in an unknown state now. But normally you uninstall by going to th...
Hi, Normally you can just use the installer like any other program to install and uninstall. No file deletion or messing with the registry. I hav...
Hi @eric91 and @hansl, Lots of people run from high to low RPM, all the tractor pulling people for example. You don't need a minus in front of the s...
We sure can help. The EC38 is an eddy brake engine dyno, correct? Send a few pictures to jostein@yourdyno.com and I can recommend a setup.
Hi, you need to set the Pulses per revolution to the effective number of pulses that YourDyno sees per BRAKE revolution. So if the trigger wheel is no...
Hi, Only one system must be connected at any one time, this is the most important. So disconnect everything from Dyno Dynamics when using YourDyno a...