Q&A Forum

Hi, For sure I would buy the KMTronic relay board. This is a much better solution than the USB relay board, and very reasonably priced.

Not really without seeing the problem. But I can login remotely and take a look. Install Ultraviewer and let me know a suitable time by message on wha...

Hi, The MOI wizard needs the circumference of the rollers (or wheel in case of a hub dyno) to be set in Plugins->Speed and distance. With this...

Hi, The pro software is the same as the standard YourDyno software, plus the following: Support for 24 bit load cell resolution, 8 aux channels, ...

Hi, The YourDyno box needs to be connected for the data to show up, is that the reason? I checked the VM167 now with the latest software and it is w...

Looks like it cannot load ControlCan.dll. It should be in the install folder c:\program files (x86)\YourDyno. Start the installer again and click Repa...

@v12power as I think you can imagine, there would not be much business to have with YourDyno if that was possible. The software is free, but it is loc...

Hi, black and green should be correct. Can you measure at the connector when you connect it to YourDyno and when not? Could it be some issue with two ...

@marco, thanks. The translations need a revamp!

Try this (attached). Not sure about big or little endian, just try both if needed. Cheers  Capture.JPG

Hi guys, YourDyno version 3.2.163 beta was released today. Changes: Ability to Zero the loadcell calibration without doing the full calibrati...

Did you check if the engine runs fine on resistorized spark plugs? There are some general EMI troubleshooting guides here, not made for YourDyno bu...

If even the screens black out then there is massive EMI. First thing to check is that you use resistorized spark plugs. Non-resistorized spark plug...

Hi, Do you mean the tacho in the car shows 2000 while YourDyno shows 1600, or are both YourDyno and the car's tacho showing 2000? YourDyno will co...

Hi, I can send you some. Send me your address to jostein@yourdyno.com