Q&A Forum
@rub87 thanks! Only ELM327 adapters are supported at the moment, so better get one of them
@force26 when I said rewire, I did not mean rewire the coils themselves (unless they are damaged of course). Just how the coils are connected to each ...
Hi, A stage is one coil. You have 16 coils so you should see 16 x 0.75 = 12 Ohm. This will give around 16 Amps at 192V. If the retarder is wired ...
@rub87 got some other folks reporting the same thing. It is a setting in the options file that causes the bug to appear. You can delete the options fi...
Hi, Steve. Better contact me directly so I can see what is going on. Call at +47 4840 1279 or mail at jostein@yourdyno.com
Hi, You can use version 3.2.165 or you can go for the newest 3.3.x version which supports the new Standard v5 and Ultimate boards too.
The Innovate clamp is just a clamp, there is no electronics in it. The all new YourDyno Standard v5 and the YourDyno Ultimate have an inductive pic...
Hi, no problem to mix and match. The relays are separate, and each relay can either close or open the two connections.
You can change the colors by clicking on the color labels. You cannot have them fixed color, new runs will come with a new default color. No, there ...
Hi, You turn on and off graphs with the V hotkey or right click and "Select visible graphs". You can move the graphs around to the left of right ...
Hi, The best here is higher resolution screen. You will have place for much more graphs and information then. You can move the graphs around, just...
Hi, You can do that in the CAN tool plugin. Here is the formula for all CAN channels: Value = (Raw data + Offset) * Multiplier / Divider So you ...
Folks, A bug has snuck into the previous version; the weather station data was not updated all the time. Fixed here. YourDynoInstaller_3.2.168.exe
Tuners, YourDyno version 3.2.167 was released today. Most important change is a different handling of manual start and stop. Several of you asked...
Hi, I tested the USB CAN again just the other day and all was fine. Note that the two buses are named 0 and 1 in the software while they are marked 1 ...