Q&A Forum

Hi, The 5V has an automatically resettable fuse that can hold 500mA (total consumption on the 5V connectors). This is normally enough for quite a lo...

Hi, This can be done today. Make a Math channel with a fixed number, for example like the attached picture if you want an AFR target. Then drag this c...

@bendd Dark mode has been pushed a few times, there has been so much work on the Ultimate and Standard v5. Still on the list!!

Hi folks, YourDyno Version 3.3.15 is available now. Changes: For Ultimate and YourDyno Standard v5: Engine RPM pickup (inductive pickup o...

Extenders work fine. I recommend an isolated type if there is a chance of different ground potential (which is not that uncommon in shops). Here is on...

Hi again, I tested what I believe is your setup. Power sweep, start RPM 2300, end RPM 800, 50RPM sweep rate. It logged always down to 800, I tried ...

Hi, Can you post the csv file of the run? Or send to me by mail to jostein@yourdyno.com. Note that you in any case can choose auto or manual start/s...

Hi there, Most water brakes are regulated at the inlet, but not all. Kevin Hamilton is the expert on different models and history, he is on a short ...

Hi, YourDyno uses USB 2.0 Full Speed, meaning max 12MBit/s. There should be 12Mbit/s available for YourDyno, although it does not use up the full ba...

The formula is LambdaDeviation = (lambda - target) / target. Assuming you have an Aux channel called Lambda, you can do: ("Lambda" - 0.83) / 0.83 ...

Hi, that is quite old hardware. I may need to create a special code for that. Can you send me a pic of your board on jostein@yourdyno.com?

Tuners, YourDyno version 3.3.14 is available now. Some nice changes 😀! Support for built in CAN bus for YourDyno Ultimate and Standard v5. Supe...

@anakin, for a hub dyno you need to enter the circumference of your car's wheels, since they rotate at the same RPM as the hub. For the MOI wizard t...

Hi folks, Version 3.3.13 is available now. It includes a fix to the CAN Bus plugin and a full update of the German translations. Enjoy!

Hi folks, Version 3.3.11 Beta was released today. This version supports YourDyno Standard v4, Standard v5 and YourDyno Ultimate. There are a numbe...