Q&A Forum

Hi, This is on the to-do list, it is not available yet. It is fairly high on the list, so expect to see it within 1-2 months.

Newer software versions store more data before and after the run in the raw file because it needs more data due to an internal change. That is the rea...

1) Check that you have the Pulses per revolution correct in the RPM/Freq setup2) Set the circumference of the rollers in Plugins->Speed and distanc...

Folks, YourDyno version 3.3.40 is available. It fixes the issue in version 3.3.39 that it would not remember the brake setup. Cheers

Hi folks. 3.3.39 has an issue that it the brake control jumps to PWM if it was set to Stepper every time you restart YourDyno. You can set it back to ...

Tuners! YourDyno software version 3.3.39 was released today. Changes: Ability to turn on and off the live table. Just right click on it and p...

500kg is good.

Yes you need at least 1 RPM sensor setup to read the brake/roller RPM. Do it like this: 1) Options->RPM/Frequency channels: Set RPM1 to be Loa...

Hi, The load cell should be placed 90 degrees to a line from the middle of the brake. The load arm (or more accurately, the line from the middle of ...

You are right, @rub87, thanks. It will be fixed in the next release. If you are in a hurry, download this file athChannels.dll and place it in C:\Prog...

Hi @godspeed-dyno, Glad you got it connected. YourDyno Standard v5 needs software version 3.3.x, as you figured out! The load cell can be connecte...

Hi folks! YourDyno software version 3.3.37 was released today. It has some nice features! Changes: A small configurable and movable table sho...

@furntrattrene there is likely something wrong in your settings. Exit/kill YourDyno then go to the folder: %localappdata%\Fonneland_Engineering_AS and...

With the KMTronic relay unit you can set hotkeys.

@stephen-booth Yes, but you can turn the inductive clamp around the other way if you get it wrong. It is not a problem if you get it wrong. Note th...