Hi,in my setup can be useful control radiator fan from yourdyno like thermostat. For example check liquid temperature with thermocouple and start fan only if temperature is higher than 40 C.... 

Any plan for a plugin system to use thrid party modules ? 🙂

or extended hardware with more user I/Os to be logged ?

Posted by: HondaRulez

Any plan for a plugin system to use thrid party modules ? 🙂

or extended hardware with more user I/Os to be logged ?

Is that you Ferenc?

+1 for loving to have a plugin system.
Got a lot of info from my tuning softwares that would be nice to be able to log on dyno runs or share dynos info with software.

yes, it's me 🙂

Found a repeatable bug.

Doing manual steady state load.
If you forget to uptick the "brake on" check box and then just go to brake setup and change to sweep.
When its coming onto starting the load of the run brake will just come on 100%

You need to close the run window and re-open it before it will work normally again.

Thanks Bmgjet. Will fix! 

Also some improvments surgestions that iv found would of been nice from the live stream I ran with the dyno screen overlayed as PIP.

Being about to resize the guages on the run screen with X and Y unlocked.
The digital guages use a lot of space because they remain letterbox scale like the analoug guages.

Being able to resize the text headers.
I ended up just draging half the guage off the screen to hide the text and using OBS to overlay text in its place because of this.

Being able to change which guages are on top of the others.

Can we get option to show analog gauge as well as digital gauge of same parameter? Or maybe an option to have analog gauge with maybe a small readout at the bottom of it in digital. 

I like the idea of an analog gauge with a digital readout at the bottom. I will look at how much work it is.

it's possible to edit lines of whp / hp separately? i can't notice too much the dot line even editing line thickness. thank you!

P.S. Hub Dyno 4X4 😀

Would it be possible to get the timing or other data from Odb2 and display on a gauge?

Was thinking the other day that a rolling graph could be useful (one that updates in real time, and user set how much data, ie, last 10 seconds or 60 seconds etc).

Would be useful for tuning PID loops on boost control, O2 control etc, a lot easier to see trends in oscillations / fluctuations etc. Maybe the screen would be getting a bit too crowded though, so wonder if it would be possible to make the software more compatible with dual screen setups, possibly have the current setup how it is on one display and be able to have the rolling graph full screen on the other display showing aux channels or RPM etc, being full screen would make it much easier to read from the car as well.

Hopefully that makes sense.

Orac12, yes I agree with you, I have thought of that too. I will look into that. 

09rocktown, yes, I plan to make this possible soon. 

Also I have thought maybe some basic safety limits that will bring a warning up on the display and let the dyno operator to back off. Maybe a warning that comes up first saying you are approaching the limit, and then another hard limit to say to immediately reduce speed / torque.

Max hub / roller speed

Max torque

A warning system will be interesting. For my dyno I will make also a system for monitoring vibration and temperature of hub bearings.

You can develop a multi sensors module that communicates via wifi with yourdyno hw and replace the internal env. sensor with the wifi receiver. Env. sensor like other sensors will be connected to this multi sensors module that can have also additional inputs and outputs.

it is a lot of work and the improvements can be unlimited