Q&A Forum
Hi
I have 2 eddy current brakes connected, through LSA-H3P25YB units, but when i do a break test, only Out2 i putting out PWM.
Both brakes are buzzing in output mode, when there a connected to Out2. But not Out1
IMAGE : https://photos.app.goo.gl/Hdekngfoo5q3GvxKA
Break 1
LSA-H3P25YB Com -> YourDyno Out1 0V
LSA-H3P25YB Pwm -> YourDyno Out1 OutA
Break 2
LSA-H3P25YB Com -> YourDyno Out2 0V
LSA-H3P25YB Pwm -> YourDyno Out2 OutA
I also seem to have the same problem with the no show "Control brakes independently" on some computers. I have 1 that shows and 2 that dont show this checkbox.
https://yourdyno.com/community/questions-and-answers-questions-and-answers/secondary-brake-not-work/
I'm not quite sure about the Out1, Out2 and OutA, OutB setup.
https://yourdyno.com/YourDynoHelp/brake-control-basics/
https://yourdyno.com/YourDynoHelp/eddy-current-brake-control/
Can you please advice.
Best regard
Lasse Kofoed
Denmark
Hi,
You need to use 0V and OutB for PWM. I tested 2 PWMs just now and both outputs work like they should.
You need to define 2 load cells to enable 2 brakes. You will not see the option Control brakes independently if you only have 1 load cell defined.
I will add some more details in the wiki.
Let me know if you have further problems!
Please report how those Loncont regulators work out. There was another guy who tested a version similar, but the regulator was too slow. There are different versions of them, so let us know! I see it can use a 0-5V analog control signal too.
Thank you. Read a post description jumpers, and with google i found this page.
https://yourdyno.com/automatic-brake-control/
I think that should be in the wiki as well, along with the outB being the primary output.
Break 1
LSA-H3P25YB Com -> YourDyno Out1 0V
LSA-H3P25YB 0-5v -> YourDyno Out1 OutB
Break 2
LSA-H3P25YB Com -> YourDyno Out2 0V
LSA-H3P25YB 0-5v -> YourDyno Out2 OutB
And both outputs are now working as expected.
I will report back about the Loncont when i know more.