Q&A Forum

try to speak in english if possible, so other people with same problems could be find this kind threads and be helpfull! or make below france language...

looks like good brake there, i havent sheet but you can talk with Frenesal, they are in Spain , ive been talked with Jesus from Frenelsa ago long time...

F16-160 would be ok. I will go minimun for F16-250.

It's very difficult to calibrate a Knock sensor since each engine has different frequency so when you test one car and your sensor thinks car is knock...

Hi! i did create an account, but i sent separately my dyno info..

cool then! post some pictures, may help to someone with similar dynos and slippage problems!

that setup will be good if you use ramps and dyno is not in the ground.

Madrid. try to look F16-160 as minimun, anyway if you have any truck yunyard near yo your location, visit and see what they have, Telma is another b...

another spanish user 👍 . Bienvenido al foro! It's all about what your target, power you wanna handle , if you wanna handle 500hp at steady mode or j...

Correct, insulation is the right word lol. I did that test using 230v...veeeeeery dangerour!! Prepare some nuts for wheel to these bolts, because...

looks like the same as my brakes!! the Telma engineer from my local city, when i went to telma for buy grease when i bought these, he asked me for wha...

i dont get what you means exactly, i see 2 different graphs. weird thing is you get retardation run every pull, never had problems with that, are you ...

Dont worry, older yourdyno versions, that spikesadded to the final run, then was a big problem, right now, if you have a bit of that spike at the end ...

good job!! 👍 👍

not, im not familiar with water dynos,sorry!