Q&A Forum

ChatGPT came up with this and I likely have the parts. my assumption would be take the tach signal and a common ground and run that into the optocoupl...

I have used the exported run data and imported that into excel using a pivot table that allowed my to create a table with RPM and throttle on X and Y ...

You should be able to use the CAN bus setup and analyzer just like you CAN bus sniffer. Make sure to "Enable CAN bus" and then click "Start"   ...

When installing my load cell I too thought the load cell angle was an issue however measuring the plate (don't have those numbers on me) The 0.500" st...

This came up once before, you could install the CAN bus plugging which allows the full range of CAN bus speed settings. However I believe the plugging...

If the run failed to open, trying Options-Load Selected Options (Engine/Vehicle dependent or All) and then clicking rerun did nothing. Trying to iso...

For what it is worth I wire in the Raytek RAYCI3B10L sensor today, no issues, working fine.

Jostein, would it be possible for him to use the built in CAN channel on say a V5 or an Ultimate and then install the CAN bus plugin and effectively t...

If you are incapable of modifying and matching CAN bus rates on devices you wish to work with on a single bus, there are inexpensive to expensive CAN ...

If you are Y-cabled into the CAN at the digital dash the you should see some CAN traffic if the dash sees traffic. Technically the bus architecture is...

Couple questions 1. YourDyno or YourDyno Unavision What version of YourDyno hardware (I believe earlier versions did not have built in CAN) Th...

Do you have a DBC file for the Sniper system?   If the answer is no the attached file may help.  techlibrary_holley_efi_can_info___dbc...