Posted by: @hansl

↑

Awesome. Are you just connecting Canbus from a Powervision to the Yourdyno Canbus input?

No, it is software level based channes from PowerCore suite.
Depending on the H-D bike year there are different comunication protocols.
For earlier bikes J1850 has been used, and CAN is for later models.
I've connected Dynojet Autotune to the YourDyno CAN bus and it works @1mb/s speed. It s just 2 channel Wideband to CAN controller. Unfortubately there are no information about data bytes. Seems that AFR (or Lmbda) of Channel 1 consist of two bytes D0+D1, D2+D3 for Channel 2, D4 and D5 are always zero, D6 and D7 are status (heating, ready, etc...). Maybe I'll make some reserches and calibration to make an equation.

Posted by: @r-horn

↑

Is this available?

Testing is still ongoing, perhaps a little later.

Is this available?

Awesome. Are you just connecting Canbus from a Powervision to the Yourdyno Canbus input?

That is cool! What hardware device is used to read the data? 

How it looks in the software.