Q&A Forum

I have also issues with start the programm after update to version 3.3.84.

Does the new version 4 even have a CAN bus? I'm interested too. I use 2 Yourdyno (old model) on the engine test bench and on the roller dynamometer

The red Line on the ground is Lambda, when CAN Lambda is selected as visible Graph.

@admin, i think the Solution is right. It is exactly the same name as in the sreen.  20210806_114827.jpg

Hi Guys, I use Ecumaster to CAN and the Chinese USB to CAN. This works so far, the lambda value is displayed on the screen. Unfortunately, the lambda ...

@admin, from one of the Manufakturers (KMS MD35) i have a DBC File. Maybe that can be helpful ? I also work a lot with Ecumaster Black. I can extrac...

Hello admin, could you please provide a kind of library for popular CAN messages for sensors and aftermarket ecu`s. ? Suitable for the cantool plugin....

@admin Thank you. I will order it asap. Best Regards Frank

I get only 000000000  20201208_1648551.jpg

Is there still a Problem with the CANTOOL ? I would like to connect the Ecumaster EGT to CAN, Lambda to Can and also Ecumaster Classic ECU with Ecum...

Hi Guys, i am loocking for the right parameters for Schenck Eddy Current Engine Dyno W260 . Hope someone can give me advise , because PID setting ...

Thank You Jostein, that was the problem. But in the Beta Version is no way to set it manualy, so i installed last Version and now i can see the Torque...

Yes, we Build this System a few Years ago. It runs properly and hold the RPM very good, but the Torque reading in steady state Condition is bad. I see...