Q&A Forum

Breastfed
@breastfed
Member
Topics: 6 / Replies: 15
Reply
RE: [Plugin]CANTool

Correction... How do I define the "start bit" for just the 12 bit's of data ? Breastfed

1 year ago
Reply
RE: [Plugin]CANTool

Hi I have the CSS electronics CANmod.Temp, In the CAN Device Setup / Chan name =TLTemp / byte offset =1 / Data length =2 / Offset = -2048 / Mult...

1 year ago
Reply
RE: "plugin copy error" & "error loading plugin"

Hi not that I recall, I don't have any folders named "YourDynoPlugins\SequencerPlugins" Ended up uninstalling and deleted the folders and reinstall ...

1 year ago
Reply
RE: Axial Grooves for traction in the Roller

Thanks for the reply Marco nice work ... Whats the pitch of that knurl ? Breastfed

2 years ago
Topic
Reply
RE: TELMA F2200 Coil Resistance 0.37 Ohms what Voltage Selection

Hi Regards to "YourDyno Eddy Power Supply setup", example if this was set to 96V, I'm not aware if there's any feedback or closed loop operation so ...

2 years ago
Reply
Reply
RE: Latest software version

Hi I still have get the same issue after installing KB5007289 Breastfed

3 years ago
Reply
RE: Latest software version

Kindly advise what version for the .NET framework? I'm using W10 64bit which updates almost monthly. Breastfed

3 years ago
Reply
RE: Latest software version

@admin I have uninstalled V3.2.59, rebooted, installed with Administrator ...and without, still no joy However V3.2.59 will install no problems. ...

3 years ago
Page 1 / 2
Select your currency
EUR Euro
USD United States (US) dollar