Q&A Forum
Hi folks, YourDyno software version 3.3.28 was released today. Changes: Improved performance on the CAN bus on the Ultimate (lower CPU load a...
Hi, It is a digital I2C signal. It can be extended but make sure to use a shielded cable.
I doubt it is noise. More likely the voltage is still at the edge (check with an oscilloscope if you can). If needed you may be able to run the input ...
@palo31 Engine RPM is always equal to the brake (or roller) RPM * Gear ratio. This is the main RPM in the system, where power etc is calculated from. ...
Hi, check that the optocoupler is strong enough to bring the voltage down. It has a 500Ohm pullup inside the box.
Hi, An i5 or better is recommended. It has 4 cores, which is the minimum recommended. The CPU is doing lots of things in parallel in real time and t...
Apologies, but one more release then I will shut up for a while :-). This is for the water brake folks. The stepper motor settings were not saved corr...
Hi folks, YourDyno version 3.3.19 was released today. This is another pure clean-up release. Now the manual axis settings of all graphs are st...
Hi folks, YourDyno version 3.3.18 was released today. This is a pure clean-up release: Clicking Restart in the Run window would sometimes not wo...
There is a fixed termination resistor in the YourDyno unit. Regards Jostein
Hi guys, YourDyno version 3.3.17 was released today. Here are the changes. Support for 4WD hub dynos on YourDyno Ultimate Individual brake ram...
@cstrick9 your points are correct. You can use the direct engine RPM channel as your X-axis (Options->Results vs XXX) and with a Math channel you...
The transistor board should work. However, you cannot hook the alternator up to a 24V power supply and "charge" that. You could connect to a discharge...
You can use a transistor that shorts the output of the alternator, controlled by a PWM signal from YourDyno. The H-bridge you linked to may work, b...