Notifications
Clear all

where to mount the YouDyno unit  

  RSS
 Udo
(@udo)
Member

The sensors for airpressure and airtemp are integratet in the YouDyno unit. For that I want mout it in the dyno room but in the past we get some massive problems with electric smog special with distributor ore magneto ignition.

Is there somthing that I must have care when I install in dyno room?

Quote
Posted : 12/01/2020 10:26 am
(@admin)
Member Admin

Hi,

Indeed the weather sensors are built into the box. If you want to place the box inside a cabinet, then I recommend using this external weather sensor and install this plugin. The sensor is about usd 70. 

ReplyQuote
Posted : 12/01/2020 6:48 pm
 Udo
(@udo)
Member

Do you supply that units?

Should I use such filter:

https://electronics-shop.dk/galvanically-usb_isolation

ReplyQuote
Posted : 12/01/2020 7:21 pm
(@admin)
Member Admin

No, I don't sell the Dracal unit, just buy from them. 

No need for such a USB filter unless maybe if you test very electrically noisy engines. Take care not to route high power/noisy cables along the dyno cables. 

ReplyQuote
Posted : 12/01/2020 7:35 pm
(@eric91)
Member

Since when I moved bluebox out of dyno room I never had lost connection problem during test. I only still have noise on load cell at certain rpm only with certain engines but I font know the origin of problem. Im using dracal wheather sensor that have no noise problem. 

ReplyQuote
Posted : 15/01/2020 3:31 pm
Share:
Select your currency
EUR Euro
USD United States (US) dollar