Q&A Forum

Good! i guess leaving it to Zero, Will not Works, does it? it's important to my dyno since we measure drivetrain losses for HPcrank calculation..

I'd recommend to put 2 points as the rear side..distancia , just put a FWD car in your dyno, and see how it sits for to put points in the rear side, i...

Hi! ive been playin a bit with Print page setup. set Font doesnt work properly, tried to change size and nothing happens.. should be good to make a bo...

Sounds good everything! definitely i Will try again to use Load control for my hub dyno, looks like it Will be the best option instead RPM Curve , i l...

Hi, hope this help, I use telma brakes rated at 2800rpm for max. speed, any problems so far.

Hi! any forecast for 4WD HUB dyno mode? i Will receive +2 load cells this week :D.

You have to configure PID control.

Check Printer setup. Also, try another thing, when you go to File --> Print , choice Microsoft print to PDF, Ok, try to print , it Will make a PDF ...

Try looking previous pages on this thread.

Hi Edgars, as i said, i dont use power sweep on my hub dyno, looks like power sweep should be the best choice for hub dyno but not, just the only 2 ti...

i Would recommend to make a video showing the bug, then go back to an older stable versión until get fixed.

Yourdyno only have 2 pin, ground and signal. you need 5v supply. then connecto to C. what i did for sensors i use in my dyno, i take out 12v and 5v fr...

see this on BMTune group. amazing! do you know how much Will cost registered versión?

correct!