Q&A Forum

I have Froude F209 that is also max 1400rpm They was orginal used for Group C BMW F1 and Jaguar 220 My is controlled by water outlet. I have all...

i fixed the problem. Connect the black and white wires and an ocoupler Drago DK 8000, DK8000-016, Isolation Amplifier 0..5 V to 0..5V built-in. This...

Here again, I get a new Spartan device for free from 14point7 (thanks) This is working now (LED signals are as the should) but the problem is the ...

to many projects and so less time. I still working on the problem with the Spartan WBO but hopfully next week I will test motor and dyno

The Spartan2 was defect from the beginning. Is there an alternative? I don't want to by another from 14point7

Sorry for long delay but that project but healthy problems cured now and I motivated to work further with that

I used screened cabels now on all sensor wires and for stepper motor. It comes muuuch better but the main problem I think is the monitor port to HDM...

When nor conected toYourDyno there is only 0.3mV but it looks that there is some potential. When messure ist show 300mV but drop down to 0.3mV Is Yo...

yes I now that but I was a little afraid about the coil of this rare vintage magneto. I will screen the cable and distributor like in Gen2 Corvette ...

Thanks for quick help. Problem is that this vintage magnetos need no resistor plugs and cooper wires. It an engine dyno. The electronic is outside...

I use the KMTronic relay box and when I try to switch by hotkey it will just flashing not hold the chosen relay channel even by holding the switch pre...

@bendd I have the same thinking with the voltage values

There located in north Germany. Made offer when inspect them