Q&A Forum
I used same diameter coil wire as the original coil wire was. I wind the wire about 240 loops (if i remember correct) to get same resistance as the or...
The insulation resistance of the coils were too low, so i had to replace them. I made new coils myself from a new aluminum coil wire. I hope you hav...
Yup, the coils are pretty stuck in old eddy brakes, i had to destroy them all to get removed 😄 26236615_10212745066154258_1260585192_o.jpg
I have also about 10m long shielded cables for hub dyno, working with no problem. I have 3 cables going to brakes, wrapped with fabric heat shrink tub...
I would like to have this mode too. It would be handy when you tune ”road driving” and half throttle area. Throttle enrichments, etc...
I’m using Bosch 0261230439 MAP sensor. It can measure from 28,9 kpa to 400 kpa so it can measure 3bar of boost 🙂
I agree with this. Software starts to come very slow when there is over 20 runs open... One thing what could be improved is the colors of the lines, i...
The scale is automatically corrected after a run, after a run you can also zoom in/out. This works fine, dont worry 🙂
I'm having a slow response if there is about 5 or more runs. Scrolling through, deleting, viewing, etc. of runs can take long times and is a bit frust...
No worries, its nice to see that the software is developing and gets better and better all the time 🙂
Hi For the hub dyno the inertia is low for sure. But this car witch i am working with is making 370nm at 4000rpm in static run and in acceleration run...
Yes, i made the adapter shafts myself. With a small manual lathe it was bit PITA to make them 🙂 Im sure any machine shop can make these adapters pret...
Hi I tested this with the newest 3.01.47 version and the change of the MOI didnt effect the power/torque readings at all. Only turning on compensation...
I made coils with lathe witch had lap counter and stand for coil wire. Make sure you do a resistance and insulation resistance measurement with 1000 v...
Posted by: Force26 Hi, I bought couple of Telmas from junkyard... I would like to disassemble them for cleaning and rewiring. How can i uninstall coil...