Q&A Forum

Do you have a DBC file for the Sniper system?   If the answer is no the attached file may help.  techlibrary_holley_efi_can_info___dbc...

I currently am running a powered usb hub with switched on the ports, rather than unplug and plug I am cycling power on the port.

Then scale 0 to 1 it this example it is still the KMTRONIC plugging name relay 0 (which is 1) and relay 2 which is one ect ect.  IMG_20251020_...

If you set up an action in the KMTronic plugging it will show up as an available gauge 0 off and 1 On  IMG_20251020_141848190.jpg

I thought I could set that up as a vertical gauge scaled 0-1 but not at the dyno at this time. I have been finishing the set up and testing on my Dy...

Professor Google below seems to indicate polarity from the power supply does not matter ____________________________________________________________...

From above: Roller RPM 400 @ 21 mph (Your dyno 30T trigger wheel frequency 200hz) Reversing this 400 RPM/60 seconds = 6.666667 rev/sec 6.666667re...

Any updates on your project? I did end up with a dynojet 250i and everything is still working on the EX stack and the WinPep 7 software but I went a...

The sensor on the Dynojet 250i is a Raytek RAYCI3B10L

This is how mine is wired stateside 240 volt, factory dynojet. I forget the exact resistance on mine but thinking it was 13-14 ohms.

@baronrojo I would love to hear more about your conversion. I have my 250i up and running with EX stack and WinPep7 but would like to add a strain gau...

@baronrojo did you finish this upgrade? Currently looking at 250i with a Winpep 7 EX stack and the computer and software is also missing Olso ...