Q&A Forum

@sigve_b make sure to click Log data on the channel in the CAN setup. Then if the Run window is open, restarted since channel setup was changed. It wi...

Alright, folks, UnaVision 4.1 is here! Version 4.1.03 was released today. New features: Awesome new graph library, check the video here: . This...

Do you mean like a 3D graph with for example the X-axis is RPM, Y-axis is Map and the Z-axis (or color) is Power? For an ECU map this makes sense,...

Hi, Another quick update for the Ultimate V3 folks, fixing a 4WD hub issue and USB initialization issue. UnaVision version 4.0.67 Cheers.

Hi, Quick release of a UltimateV3 fix where Auto zero of the water brake valve would sometimes hang up when using Ethernet. Also fixed Average readi...

It needs a 0-5V 100Hz 0-92% PWM signal.  

I addition to what @r-horn says, make sure the bike is grounded. There are several CAN buses on the S1000RR and you have to know the format to deco...

Hi, You can create a results table with the channels you are interested in and the master channel of your choice (Time or Engine RPM typically), and...

Thanks! Very nice installation and great write up! You are right about the angle of the load cell. It does not need to be 90 degrees to the rotatio...

Yes, 125kBit/s can be included for the future

The stepper moves a maximum of 1600 steps to find the zero position. This is 4 full revolutions at 400 steps/rev, or 8 if you use 200 steps/rev. If it...

Sounds good. In practice the MOI will be a little higher than what is stamped, due to the MOI of the bike that comes in addition.

This is coming.  

Hi, The quick guide: Select Inertia dyno in the Options->Dyno type and profiles Then out a standard car on and adjust the Moment of Inertia ...

Hi guys, UnaVision version 4.0.64 was released today. Changes: Visual indicator of the brake ramp up using a light blue color. This makes it ...