Q&A Forum

Folks, to those reporting the gauge screens don't stay in some setups. This is due to a new check that was supposed to check whether the window is out...

@martino-montefiori, thanks for the kind words. CAN out is very easy to do with the newer YourDyno units (v5 and Ultimates) but with the v4 and the CA...

@hondarulez each run includes the settings for that run. These settings never change, they are tied to the run forever. If you want to re-run a run...

@hansl please message me at +47 4840 1279 and I will take a look at your setup

@hondarulez when doing a rerun, you must make sure the settings are the same as when you did the original run. If you have done any changes, then clic...

The CAN out is made such that it sends the channel values out continuously. If a channel is start/stop (02h/05h) then it will send 02h as long as the ...

Folks, UnaVision 4.0.47 was released today (Beta). Some nice new features! New features: Ability to adjust the Font size (Options->Font siz...

Check the new software version coming today, it stores more data after reaching the end of the run

You can send out any data channel on the CAN bus. There is a little trick if you want to send a hotkey over the CAN bus. Install the KmTronic plugin (...

Yes, just use two profiles or backup/restore options

New brakes can be bought from European manufacturers like Klam, Frenelsa and Telma. They are all very good. There are also Chinese alternatives at som...

You can use the YourDyno water brake valve. They are $1495. Alternatively buy an eddy brake. Eddy brakes are by far the most common for chassis dynos,...

That is fine. Just make sure each one has a different CAN id and configure each id in the software. You can call them AFR1, AFR2, etc based on their i...

With UnaVision, all settings are saved with every run. But with the old YourDyno software, this was not the case.

Hi, Go to Options->Speed and Distance and set the diameter of the roller, or wheel dimensions if you have a hub dyno. This was previously under...