Q&A Forum

The CAN out is made such that it sends the channel values out continuously. If a channel is start/stop (02h/05h) then it will send 02h as long as the ...

Folks, UnaVision 4.0.47 was released today (Beta). Some nice new features! New features: Ability to adjust the Font size (Options->Font siz...

Check the new software version coming today, it stores more data after reaching the end of the run

You can send out any data channel on the CAN bus. There is a little trick if you want to send a hotkey over the CAN bus. Install the KmTronic plugin (...

Yes, just use two profiles or backup/restore options

New brakes can be bought from European manufacturers like Klam, Frenelsa and Telma. They are all very good. There are also Chinese alternatives at som...

You can use the YourDyno water brake valve. They are $1495. Alternatively buy an eddy brake. Eddy brakes are by far the most common for chassis dynos,...

That is fine. Just make sure each one has a different CAN id and configure each id in the software. You can call them AFR1, AFR2, etc based on their i...

With UnaVision, all settings are saved with every run. But with the old YourDyno software, this was not the case.

Hi, Go to Options->Speed and Distance and set the diameter of the roller, or wheel dimensions if you have a hub dyno. This was previously under...

@mac3ce all this is possible. Just right click on the heading of the Session and click New custom parameter The Runs is already there, it is called ...

OK, so there is a clutch to disengage the fronts or the rears. You can do 4 profiles to match that if you prefer. I would expect the AWD mode to wor...

If the dyno has permanent 4WD setup (no clutch or ability to disconnect front and rear) and brakes are connected together in the middle, then you only...

Hi, Good questions. You can use one circuit breaker per power supply. The circuit breaker should be rated for at least 20 amps. All modern electr...

Here you gospan>hansl.yourdyno