Q&A Forum
Hi, You can do this with the KMTronic relay module. It will be as fast as any YourDyno output. You set it to trigger on an RPM set point.
Hi, Power and Torque are calculated at the roller. Engine Torque is calculated from roller torque divided by gear ratio. If you have a difference be...
Approved now
Digital inputs are configured where you configure RPM and frequency channels. Choose Digital on/off channel in the pulldown menu. The software for usi...
Tuners, YourDyno version 3.3.16 was released today. Changes: Support for flow meters based on pulse count. This can be fuel flow, water flow ...
Hi, we have a kit for that! You keep the mechanical parts of the valve, and replace the servo with YourDyno's and replace the Superflow DAQ. You ca...
Would be interesting to see. Are you able to post it here?
200VAC is ok 🙂
Engine RPM and RPM2 shall show the same if you use RPM2 to calculate gear ratio. Engine RPM = RPM1 * Gear ratio. RPM1 and RPM2 will not show the same ...
@osi on the Aux question. If you want you can call the Aux channel say Raw TPS, then set 0V to be 0V and 5V to be 5V. Then you can create as many math...
@madswp backup the options to file, open the file in Notepad or another editor, search for the -15 (it will be brakeSweepRate or something), set it to...
Hi, In the Math channel setup the channels are now called the name you gave the Aux channel ("TPS Sensor" for example), not Aux1, Aux2, Aux3, etc.
@artibig have you turned on the option "Enable correction for rolling resistance vs speed from measured retardation data"? Turn that option off. It on...
No need to shield the stepper motor cables.