Q&A Forum

Hi folks, YourDyno version 3.3.91 (Beta) was released today. Changes Much better data crop (cutting parts of the data graph). You can now crop t...

@tom-hulbert If the solenoid could open and close very fast, then at some point it will work as a regulated load, but I am pretty sure a solenoid valv...

You can use PWM to control a servo, which then controls the valve. You need a powerful servo, but there are very powerful ones out there now. Somethin...

If you connect the MSD to RPM2 then make sure to turn on the RPM2 gauge to see if it reads. The Engine RPM gauge does not automatically display the ...

Hi, What is going on here is very likely two things: You have turned on the option to record retardation data. Check Options->Basic Dyno Setu...

No, the inductive clamp is not supported by the v4 control box. You need the v5 or the Ultimate. The options are OBD2, MSD or something else that c...

Thanks @six_shooter. It works now.

About 1mm or 40 thousands of an inch is suitable.

@mark-mckerlie that is a reasonably request. I will add it to the list.

@jeppen, hook it up to power (12V if I remember right?). Signal and 0V go to Freq2 for example. Configure the Freq2 to be a flow meter. Blow into the ...

Sounds like the thermocouple was not fully isolated

@bwatson Click New tab and choose Brake setup analysis from the templates.

Hi @dave-parsons, Try out the new variable gear ratio option in the newest version. You need two RPM sensors; one of the brake and one on the engine...

Hi folks, YourDyno software 3.3.89 (beta) is released today. Changes: New handling of variable gear ratio option. When this option is chosen, th...

@hondarulez The dropdown for RPM sources is updated when you start the Run window. This is the same for the list of available gauges for example. Alwa...