Q&A Forum

What PC are you usi...
 

What PC are you using for your dyno, and how do you keep it from crashing mid-pull?

2 Posts
2 Users
0 Reactions
3 Views
(@emmaleo5585)
Posts: 1
Member Customer
Topic starter
 

Hey everyone,

My laptop froze during a pull last weekend while logging RPM, torque and wideband data, and I lost the whole run. I’m setting up a dedicated dyno PC now, so I have a few questions.

What PC or laptop do you run with your dyno, and has it been stable? Do you use a fanless mini PC, or does that cause heat problems in a dusty workshop? Have you had USB or CAN dropouts, and what fixed them? Do you use a UPS or a powered USB hub, and is it worth it?

Also, do you know a good IT hardware supplier that sells tough, reliable gear for workshops, not gaming stuff? And is there any hardware you would never buy again?

Thanks, I’d love to hear what works for you.


 
Posted : 19/11/2026 6:21 pm
(@cmadmin)
Posts: 139
Member Admin
 

You want a modern Windows 11 PC of medium specification or better. Dedicated GPU (graphics processor) is recommended, as opposed to Built in graphics where the CPU needs to do most of the graphics job.

The cheap small fan-less mini PCs are generally very slow, so don't use those. Also, some PCs are sold as "refurbished", and have very old CPU, so that is generally not recommended.

Do a google search for your CPU and benchmark (for example AMD Ryzen 7 7700X benchmark). You should aim for Multi thread rating of at least 15000 and single thread rating of at least 2000. The numbers are not absolute, it depends on the amount of data channels you run, length of the runs, number of screens, number of brakes, etc.

A powered USB hub is ok to use, with a short usb cable to the YourDyno box


This post was modified 2 hours ago by Jostein Fonneland
 
Posted : 20/11/2026 9:14 am
Share: