Q&A Forum
I need to replace a Pc on my dyno. Once I have loaded the your dyno software is there a file I can transfer from the old pc to the new pc that would have the old dyno setup? ie calibration and printer page setup
Folks, all settings are transferred if you use the Options->Backup options to file and Restore options to file. However, you MUST have the same plugins installed.
Load cell calibration is transferred.
Ok and what about the loadcell calibration?
I did this today and my math channels were xferred in the options file. Can't speak for CAN as I don't use it.
I am in a similar situation but it seems not all options get transferred, for example can devices and math channels arent.
is the dyno loadcell linearisation/calibration also included in the stored options file?
Yes, go to Options->Backup options to file on your old PC. Then on your new PC you do Options->Restore options from file