Q&A Forum
I need to replace a Pc on my dyno. Once I have loaded the your dyno software is there a file I can transfer from the old pc to the new pc that would have the old dyno setup? ie calibration and printer page setup
Yes, go to Options->Backup options to file on your old PC. Then on your new PC you do Options->Restore options from file
I am in a similar situation but it seems not all options get transferred, for example can devices and math channels arent.
is the dyno loadcell linearisation/calibration also included in the stored options file?
I did this today and my math channels were xferred in the options file. Can't speak for CAN as I don't use it.
Ok and what about the loadcell calibration?
Folks, all settings are transferred if you use the Options->Backup options to file and Restore options to file. However, you MUST have the same plugins installed.
Load cell calibration is transferred.