Q&A Forum
Hi what wide band lambda kit
Works with yourdyno module and how is it wired in ?
As we are going to looking at remodelling ours
pretty simple, just wire 12v / ground and 5v signal. i adapted 12v from pc supplier with a connector, ground, and 5v to yourdyno.
Im using Aem wideband. no problems.
Hi with what controller how is it wired and configured
Being a bit thick as the one we are currently using just plugs in all the connections and configuration are taken care of
Im using Aem wideband. no problems.
Im using a 14point7 SLC 2 Free myself.
Cost something like $20 for the controller. Then using $40 LSU 4.9 sensors from ebay.
I got 3 of those controllers so I could log AFR in 3 banks.
1 of the controllers is defective tho and over heats so there quality control isnt the best.
And Emails and Messages on there support forum has gone un-answered.
So it is kind of hard to recommend it but for the price I guess with a 1 in 3 failure rate its still cheap.
Controller is power from Computers PSU using the 12V rail (Yellow wire on molex plug)
Then earth is black wire on molex and single 0-5V wire for logging into "YourDyno" box AUX from the wideband controller.
Hi, any unit that produces a 0-5V signal, for example the Innovate LC-2 or the SLC Free 2 or Spartan 2 from 14point7.com.