Q&A Forum

Interference sendin...
 
Notifications
Clear all

Interference sending the gauges wild!

3 Posts
2 Users
0 Reactions
406 Views
(@2smoke)
Posts: 16
Member
Topic starter
 

Hi all,

Got an annoying issue with my setup, the MPH, HP, Drum RPM and TQ gauges sometimes go wild, as if there is interference somewhere. Doesnt happen all the time, but when it does it's hard to stop. It started doing it, so I bonded the screened cable between the AFR setup (lambda probe, solenoid, wideband controller etc) to the YD unit and it stopped. Then it randomly started doing it again, but only when the drum was rotating, so I bonded  the dyno itself to the YD unit, and it stopped.

 

Now the other day it started again, and the only way to stop it was to bond myself to the YD unit!

 

Bizarre! 

 

Has anyone else had a similar issue?

 

Thanks

Paul

 
Posted : 01/03/2024 12:01 pm
(@admin)
Posts: 1460
Member Admin
 

Sounds like you have some sort of grounding issue. The YourDyno box is usually grounded through the load cell shield, otherwise connect one of the shield inputs  to ground. Also make sure the dyno is grounded, the car is grounded and the PC is grounded. 

The power supply to the Lambda should be of good quality and should be isolated (i.e. minus is not the same as ground).

If 0V of one of the YourDyno inputs has to be connected to ground, then make sure only 1 of the 0V inputs are connected to ground. 

If the problem continues, try to disconnect sensors until the issue stops to see where it comes from. 

 

This post was modified 9 months ago by Jostein
 
Posted : 01/03/2024 12:51 pm
(@2smoke)
Posts: 16
Member
Topic starter
 

Posted by: @admin

Sounds like you have some sort of grounding issue. The YourDyno box is usually grounded through the load cell shield, otherwise connect one of the shield inputs  to ground. Also make sure the dyno is grounded, the car is grounded and the PC is grounded. 

The power supply to the Lambda should be of good quality and should be isolated (i.e. minus is not the same as ground).

If 0V of one of the YourDyno inputs has to be connected to ground, then make sure only 1 of the 0V inputs are connected to ground. 

If the problem continues, try to disconnect sensors until the issue stops to see where it comes from. 

 

 

Thankyou, I'll give it some work. Didnt think about earthing the bike!

 

Paul

 

 
Posted : 01/03/2024 2:04 pm
Share:
Select your currency
NOK Norwegian krone
EUR Euro