Q&A Forum

I sent you a friend request on Facebook..

Little bit of a update...I am running small single cylinder Motors...I was trying to make the pulls in 4th..I just tried again in 5th and then in 6th....

Going off the brake rpm on Dyno software it's only turning about 800rpm at the rollers...the brake is a direct drive off the roller..i could very easi...

It's a patraco mark 3 water brake Dyno for motorcycles and ATVs up to 200hp...the Dyno was originally designed to run off a garden hose..the previous ...

Is there anyway you can call me?

It just had some differences from one tooth to the next...

Not really anything for sure...with some help I have narrowed it down my trigger wheel...I'm waiting on a new one now..

I am emailing you the file now

Is that what your wanting?

KIMG3036.JPG

It has round slots but everything else is in spec...how do I get the raw log file? I will definitely send it I tired of messing with it..

It's connected right to the drum/roller...so not with out adding a jack shaft and a couple sprockets..bike I'm running on it only has a 15" tire so I ...