Q&A Forum

hi Sevindeess , are you sell or buying? i will assume you looking for a STUSKA WATERBRAKE DYNO MODEL XS 211 and questioning on prices. Like anythin...

Hi Gassed & welcome to the forum , that GM temperature sensor will work , have a look at some of arduino temperature shields sensor.

Hi Thdyno and welcome to the forum Have you read this section THE PID CONTROLLER

I'm curious to see also what the valve looks like inside!

As Admin suggested the the h&f dpx series engine dynos were made way back in the 1940s and 1950s era. You will be experimenting to get the right v...

There is no reason why you can't totally remove the very old sluice gate of the dyno and fit a v_groove( slotted) global ball valve arrangment of cor...

Hi and welcome to the forum Austin , that picture looks like a hand turn valve approximately a 90 degrees turn from fully open to fully closed and as ...

Here are a few chassis dynos that have been converted to YourDyno control system. There are many more examples plus hub_dynos too you may want to read...

You need to workout if it is possible to re_use existing sensors and other hardware of your maha chassis dyno. If the sensors are compatible specifi...

MAHA LPS 13 project. Many questions

Welcome to the forum MadMax 1. What load cell( strain gauge ) does the maha lps2000 have on it ? 2. What speed sensor and speed sensor reluctor r...

Intermediate angle V-Port valves, such as a 30° or 45° balls, produce a modified equal percentage inherent flow characteristic. Slotted balls or V-sha...

Hi James Meyers, owner of Depac dyno control systems Dave Manzolini passed away in 2018br />The depac dyno control system considered to be the best in...

Hi Steve , that sucks that the valve was lost. Have a look at Andrew's thread " Scratch built water brake " and post(s) Yourdyno" using a "Land and ...