Q&A Forum

Mach_1
@mach_1
Member
Topics: 3 / Replies: 340
Reply
RE: Stuska XS211

hi Sevindeess , are you sell or buying? i will assume you looking for a STUSKA WATERBRAKE DYNO MODEL XS 211 and questioning on prices. Like anythin...

3 years ago
Reply
RE: Intake/underbonnet temperature

Hi Gassed & welcome to the forum , that GM temperature sensor will work , have a look at some of arduino temperature shields sensor.

3 years ago
Reply
RE: PID settings

Hi Thdyno and welcome to the forum Have you read this section THE PID CONTROLLER

3 years ago
Reply
RE: L&S control valve

I'm curious to see also what the valve looks like inside!

3 years ago
Reply
RE: Sizing a servo motor for a water brake.

As Admin suggested the the h&f dpx series engine dynos were made way back in the 1940s and 1950s era. You will be experimenting to get the right v...

3 years ago
Reply
RE: Sizing a servo motor for a water brake.

There is no reason why you can't totally remove the very old sluice gate of the dyno and fit a v_groove( slotted) global ball valve arrangment of cor...

3 years ago
Reply
RE: L&S control valve

Hi and welcome to the forum Austin , that picture looks like a hand turn valve approximately a 90 degrees turn from fully open to fully closed and as ...

3 years ago
Reply
RE: Maha lps2000

Here are a few chassis dynos that have been converted to YourDyno control system. There are many more examples plus hub_dynos too you may want to read...

3 years ago
Reply
RE: Maha lps2000

You need to workout if it is possible to re_use existing sensors and other hardware of your maha chassis dyno. If the sensors are compatible specifi...

3 years ago
Reply
RE: Maha lps2000

MAHA LPS 13 project. Many questions

3 years ago
Reply
RE: Maha lps2000

Welcome to the forum MadMax 1. What load cell( strain gauge ) does the maha lps2000 have on it ? 2. What speed sensor and speed sensor reluctor r...

3 years ago
Reply
RE: Stuska dyno setup

Intermediate angle V-Port valves, such as a 30° or 45° balls, produce a modified equal percentage inherent flow characteristic. Slotted balls or V-sha...

3 years ago
Reply
RE: Stuska dyno setup

Hi James Meyers, owner of Depac dyno control systems Dave Manzolini passed away in 2018br />The depac dyno control system considered to be the best in...

3 years ago
Reply
RE: Stuska dyno setup

Hi Steve , that sucks that the valve was lost. Have a look at Andrew's thread " Scratch built water brake " and post(s) Yourdyno" using a "Land and ...

3 years ago
Page 2 / 24
Select your currency