Q&A Forum
I am interested in an answer to this too.
Someone has asked via PM about the mains filter and protection components I am using on the power supply output. The filter is to stop noise going ba...
Dyno continues to work well. Did a firmware update that seemed to lose one of my presets - 0-5V dyno output control went to PWM, and it took me a whil...
I built my own retarder power supply (parts are are readily available). I use YourDyno for control.
Thank you - she is getting better, but slowly. My engine management maps only down to -100 kPa (ie -14.7 psi) and on my dash when driving the car I do...
Bought a couple of these to act as water traps for the MAP sensors. Also bought a pair of 150mm analog gauges - they measure minus 100 kPa to plus 1...
That would be great - no hurry. Sounds like I could make it easily enough, but a pic is like 1000 words, etc.
Thanks mate. Pic?
And I have an answer! I cut open one of the failed sensors, and it is full of water drops Hmm, I definitely need a good water trap, or to use a sensor...
I seem to keep on blowing up GM 3-Bar map sensors. I am using one for measuring boost and one for exhaust back-pressure. It's the exhaust pressure sen...
Unfortunately my wife has been ill - in hospital now, and in and out of hospital over the last four weeks. However, I did manage to finish the remote ...
Thanks for all that. I've now tried flyback diodes across the external relay coils - no change. Sorry, but I can't afford to spend any more time on t...
Thanks for that - it's not your software because it does it with the 'official' software as well. When you were testing, did you have the board power...
The board is the one you nominated - via eBay. /p> USB cord is 1.5 metres long. No flyback diodes needed when using relays to trigger relays.