Q&A Forum

Julian Edgar
@julian-edgar
Member
Topics: 2 / Replies: 69
Reply
RE: Strapdown points

I am interested in an answer to this too.

5 years ago
Reply
RE: Julian's dyno

Someone has asked via PM about the mains filter and protection components I am using on the power supply output. The filter is to stop noise going ba...

5 years ago
Reply
RE: Julian's dyno

Dyno continues to work well. Did a firmware update that seemed to lose one of my presets - 0-5V dyno output control went to PWM, and it took me a whil...

5 years ago
Reply
RE: Julian's dyno

I built my own retarder power supply (parts are are readily available). I use YourDyno for control.

5 years ago
Reply
RE: Julian's dyno

Thank you - she is getting better, but slowly. My engine management maps only down to -100 kPa (ie -14.7 psi) and on my dash when driving the car I do...

5 years ago
Reply
RE: Julian's dyno

Bought a couple of these to act as water traps for the MAP sensors. Also bought a pair of 150mm analog gauges - they measure minus 100 kPa to plus 1...

5 years ago
Reply
RE: Julian's dyno

That would be great - no hurry. Sounds like I could make it easily enough, but a pic is like 1000 words, etc.

5 years ago
Reply
Reply
RE: Julian's dyno

And I have an answer! I cut open one of the failed sensors, and it is full of water drops Hmm, I definitely need a good water trap, or to use a sensor...

5 years ago
Reply
RE: Julian's dyno

I seem to keep on blowing up GM 3-Bar map sensors. I am using one for measuring boost and one for exhaust back-pressure. It's the exhaust pressure sen...

5 years ago
Reply
RE: Julian's dyno

Unfortunately my wife has been ill - in hospital now, and in and out of hospital over the last four weeks. However, I did manage to finish the remote ...

5 years ago
Reply
RE: [Plugin] Extra Outputs HID USB Relay.

Thanks for all that. I've now tried flyback diodes across the external relay coils - no change. Sorry, but I can't afford to spend any more time on t...

5 years ago
Reply
RE: [Plugin] Extra Outputs HID USB Relay.

Thanks for that - it's not your software because it does it with the 'official' software as well. When you were testing, did you have the board power...

5 years ago
Reply
RE: [Plugin] Extra Outputs HID USB Relay.

The board is the one you nominated - via eBay. /p> USB cord is 1.5 metres long. No flyback diodes needed when using relays to trigger relays.

5 years ago
Page 1 / 5
Select your currency