Went out to the shop and did some testing. If I connect the USB cables directly to my laptop and keep them away from any type of 12 volt power wire i...
Before wiring in the switches I am going to try to move the laptop over near the dyno and connect directly to the USB cables and see if that makes a d...
I am trying to run the starter motor on a SBC and the ignition system. I have the USB relay wired to activate a 30 amp bosch relay which is actually ...
So after some more testing and getting the wiring completed this doesn't look like it's going to work like I wanted. For some reason I seem to have c...
I have problems with losing connection on my engine dyno when I run the starter for too long, sometimes it does it sometimes it doesn't. A new issue ...
Just ran out and tested it, everything works well. I setup the starter relay to turnoff automatically once the engine rpm is over 500rpm. I can adju...
Got it to work now, that is absolutely awesome and I appreciate the time put in for the development and the support!!!
@bigpermgarage Yes, that is all I am seeing are the buttons on the screen which I can click to activate. I thought I deleted the original .dll file a...
So I finally got everything wired up and tested the relay board, it activates the relays but I don't see how or where I configure them to work with th...
@bigpermgarage Last dumb question, where can I get the updated plugin? The one I see on the site here is the original that I had downloaded. Thanks ...
@bigpermgarage That's exactly what I was looking to do. Thanks for the answer!!!
@admin So a USB extender will not create issues? I was just going to ask this question as my setup is going to require some type of extension. Thank...
Thanks for the quick response. I wired it the way you described and had the same thing. Then went and checked which pins I had power and ground runn...
