Q&A Forum

I have now found out what the problem was. I can't have VM167 board and USB-can module connected at the same time. So I'm guessing they using the ...

hi again. l still have the same problem that l cant connect to the can device! im using the latest software. any idea what the problem may be? ...

@austin-jones okay it is a 150 kg load cell so it will work up to 300 nm for me.

l have got the drivers from ecu master so its working now. but l have one more question. is there any lower limit for egt temp in yourdyno? ...

hi again After l updated the windows to 10 pro the egt module dosent work any longer 🤣 windows cant find drivers for it and there is no drivers ...

Hi Austin It's not working for me and l think it's because the strain gauge is missing a wheatstone bridge .So you can only measure resistance. If ...

@admin Its workning now so thank you very much Jostein 🙂

yes l have first done 0 cal. l have also tried another weight of 20kg with the same result. next step is to try another cable. if that will not ...

@admin ok yes its 4 wires . 1 ground and 3 to the strain gauge. here is a calibration video. im going to read about wheatstone bridge and...

@admin that dosent work either. see attached file for my plugins. l think it looks good?  Skarmklipp.PNG

@admin I have also installed cantool via yourdyno installation as you mention at least 5 times with the same problem. When I installed it on a...

Thank you. I have done as your instructions but the problem is that the raw value is the same all time 380-385 ( with or without load ) I'm not ...

@admin I have tried again now!. This time it was possible to zero calibrate the load cell but when l load it, it starts to gouup and down a lot! ...

@andrew okay so what can the problem be? see picture of the version im using.  Skärmklipp.PNG