Q&A Forum

Thanks! Very nice installation and great write up! You are right about the angle of the load cell. It does not need to be 90 degrees to the rotatio...

Yes, 125kBit/s can be included for the future

The stepper moves a maximum of 1600 steps to find the zero position. This is 4 full revolutions at 400 steps/rev, or 8 if you use 200 steps/rev. If it...

Sounds good. In practice the MOI will be a little higher than what is stamped, due to the MOI of the bike that comes in addition.

This is coming.  

Hi, The quick guide: Select Inertia dyno in the Options->Dyno type and profiles Then out a standard car on and adjust the Moment of Inertia ...

Hi guys, UnaVision version 4.0.64 was released today. Changes: Visual indicator of the brake ramp up using a light blue color. This makes it ...

Folks, UnaVision version 4.0.62 was released today. Fixes: For UltimateV3 only: Ethernet stability fix Frequency channels did not work for...

A load valve needs 2 outputs (Pulse and Direction) and a throttle servo needs 1 (Pulse width modulation). You can send any channel out on the CAN Ou...

@chris-harrison, click in the database table and use the arrow keys or page down to see all the runs. Scrolling with the mouse wheel when the screen i...

@bendd I will set the Created date field to read/write so it can be changed, good idea. On the colors, the power and torque curves will have the sam...

@smoore, we have sold hundreds of those pressure sensors and have not had a single failure as far as I remember, so I would double check the connectio...

No, the number of significant digits is automatic depending on the channel value, smaller values have more digits. It is a good idea for a future feat...

There is a red light on the sensor itself, close to where the cable comes out. It can be a bit hard to see in broad daylight.

Hi, The RPM works also with fewer teeth per second. The red light should be on when a tooth is near. If it is not, something is not right. Take the ...