Q&A Forum

That is good to know Eric. Thank you for sharing your brain ! Jeff

Attached is a photo of my 1" valve. ( it is 139mm long, 50mm square) So you are turning your valve slower? Jeff Valve.jpg

Yeah, 4-stroke garden tiller engines...... Based off of the Honda GX200. The 1" valve has a Gilmer belt toothed sprocket on it already. I will set it ...

Eric What king of horsepower are you making and at what RPM ? I will be testing 15-25 hp mostly at 9000 max. Using 12 gallon (45 liter) reservoir. I h...

Mach Thank you for the info !! Jeff

I am asking because I do not know the answer. I can direct couple or belt drive as needed. Belt drive would allow for corrections in ratio if needed. ...

How about one of these? 1712oz-in Closed Loop Stepper Motor NEMA34 12NM Hybrid Servo Driver 2HSS86H Kit

I should add that I am open to other suggestions to control the valve. (such as a servo) Jeff

Derk Looking good, always some bugs to work out. Did you use the stepper motor to control the hydraulic valve? I am curious if it has enough torque to...

Derk What stepper motor, controller and voltage are you using? Jeff

Derk Excellent!!! Looking forward to the 3rd video. Jeff

I use the DTech tach adapter. This is the inductive pick-up/wire/clip I used. It clips on the sparkplug wire, but I think just a length of 16-18 gau...

Will that link update my existing version or will I need to re-enter all my current settings?

When I attempt to download the new update, I get redirected to this Error 404 page...... Jeff