Q&A Forum

Notifications
Clear all

rpm input

3 Posts
3 Users
0 Likes
2,707 Views
(@schroedter)
Posts: 1
Member
Topic starter
 

What is everyone using or going to be using for engine rpm(not roller rpm)?  Is everyone going to go with the dtec rpm adapter or is there a better solution? Are you using a clamp style sensor for the ignition pickup? I would really like to be able to use a clamp on probe for ease of use.  Feel free to post a picture of your setups!

Thanks

 
Posted : 07/11/2018 1:35 am
(@captndiet)
Posts: 37
Member
 

I use the DTech tach adapter.

http://www.dtec.net.au/Dyno%20RPM%20Adapter.htm

This is the inductive pick-up/wire/clip I used.

https://www.pegasusautoracing.com/productdetails.asp?RecID=5109

It clips on the sparkplug wire, but I think just a length of 16-18 gauge wire would do the same thing.

Jeff

 
Posted : 07/11/2018 4:59 pm
(@admin)
Posts: 1400
Member Admin
 

Schroedter, all setups MUST have the roller RPM sensor. This is where the power is calculated, and has requirements on number of teeth, etc.

In addition you can use an engine RPM sensor to automatically calculate the gear ratio. 

The DTech adapter works fine with YourDyno. 

 
Posted : 07/11/2018 8:36 pm
Share:
Select your currency
EUR Euro
USD United States (US) dollar