Q&A Forum
The brake is maxing out. As you can see it is at 100% for a long time. Are you sure the PWM settings is correct? Test using the slider and measure ...
Hi, No, you cannot adjust the readings. Here is the pressure spec of the sensor: Pressure sensorRMS NoiseSensitivity ErrorTemperature ...
Hi, The best way is to test a car or motorcycle you know the power of and adjust the moment of inertia so it matches. Alternatively can also try to ...
Much less than 500mA. Just power it from one of the load cell inputs.
Hi, You can connect one thermocouple directly to the Thermocouple input on the YourDyno box. If you want more than 1 thermocouple then you need an a...
@motormapper check if you have the same name ("Lambda") defined as an Aux channel. Channels need to have unique names.
OK, that means the internal 12V or 5V power supply is not getting its power. Can you disconnect the mains and connect it again? If that does not help,...
Hi, can you send a video of that? I have never seen that before. The red led is on when the temperature is too high or current is too high. What do...
@vishara-jyasekara, the Maha LPS 2000 is a common dyno to upgrade. Not a problem! You need the instrument box and a power supply. If I remember right ...
So there are two coils there it seems? Do you know which voltage the brakes work at? The control signal is likely a 0-5V signal, where 0 is 0 outpu...
There is a chance you will need a new power supply. But there is no harm in trying with your existing one. You can make a guess that the control signa...
@michalis-antoniadis, I checked but cannot reproduce that. If it happens again, save your options and send me, and explain if there was anything speci...
Hi, are you sure the control mechanism is a PWM signal? To check with YourDyno, measure that the 0V input to the power supply either is isolated (best...
Tuners! YourDyno version 3.2.128 was released today. Changes: Added a math channel plugin! See this video for a presentation of the capabilit...
@mr-y Yes, I see that, but something is wrong in the setup. Send me a raw log file and save your options using Options->Backup options to file, and...