Q&A Forum
Hello, just received the YourDyno Module and there were no instructions or manual.. most connections are clear, just need some explanations on how does work the Manual control and Outs (A & B the difference between?) Thx!
p.s. will work with two Frenelsa f16-100 retarders
Hi,
That's a nice looking hub dyno.
The Out-connector is described here: http://yourdyno.com/automatic-brake-control/. You need to use the OutB pin and the 0V pin.
Manual Control is not fully released yet, but it can be used. It does the same as the buttons in the software called "Brake on" and "RPM UP(+)" and "RPM Down (-)". You connect the signal pin to 0V with a switch to turn it on.
Cheers,
Jostein
So if i need 2x Analog 0-5V controlls , i use out1 and ou2 B and 0 pins just selecting "Analog Out Setup" in the software options? That`s it?
Jumpers inside already moved to AOut1 AOut2
Correct. Jumpers need to be at Aout1 and AOut2. The analog signals will be between the OutB terminals and 0V on both connectors.
hello to made the dynamometer with f16-100 ??
with these as hubs how many horsepower can you brake at most ??