Q&A Forum

Notifications
Clear all

YourDyno module questions.

7 Posts
3 Users
0 Likes
5,199 Views
(@mihales)
Posts: 5
Member
Topic starter
 

Hello, just received the YourDyno Module and there were no instructions or manual.. most connections are clear,  just need some explanations  on how does work the Manual control  and Outs  (A & B the difference between?) Thx!

 

p.s. will work with two Frenelsa f16-100 retarders

 
Posted : 14/06/2018 9:59 pm
(@mihales)
Posts: 5
Member
Topic starter
 

my version

 
Posted : 14/06/2018 10:24 pm
(@admin)
Posts: 1397
Member Admin
 

Hi,

That's a nice looking hub dyno.

The Out-connector is described here:  http://yourdyno.com/automatic-brake-control/. You need to use the OutB pin and the 0V pin.

Manual Control is not fully released yet, but it can be used. It does the same as the buttons in the software called "Brake on" and "RPM UP(+)" and "RPM Down (-)". You connect the signal pin to 0V with a switch to turn it on. 

Cheers,
Jostein

 
Posted : 16/06/2018 12:19 am
(@mihales)
Posts: 5
Member
Topic starter
 

So if i need 2x Analog 0-5V  controlls , i use out1 and ou2 B and 0 pins just selecting "Analog Out Setup" in the software options? That`s it?

 
Posted : 17/06/2018 3:23 pm
(@mihales)
Posts: 5
Member
Topic starter
 

Jumpers inside already moved to AOut1 AOut2 

 
Posted : 17/06/2018 3:30 pm
(@admin)
Posts: 1397
Member Admin
 

Correct. Jumpers need to be at Aout1 and AOut2. The analog signals will be between the OutB terminals and 0V on both connectors.

 
Posted : 17/06/2018 9:56 pm
(@loris-peccarisi)
Posts: 5
Member
 

hello to made the dynamometer with f16-100 ??
with these as hubs how many horsepower can you brake at most ??

 

 
Posted : 21/01/2021 11:30 pm
Share:
Select your currency