Q&A Forum
Notifications
Clear all
Questions, answers and shared experiences
18
Posts
4
Users
1
Reactions
6,964
Views
I am using a Nema 23 Stepper motor. It borderline has enough torque. I also have a 17 with a gear reduction unit on it but I was worried about the speed of the valve at that point.
I just got my rpm sensor working and need to finish up my muffler setup to actually make some power runs and see how the load control works.
Posted : 27/08/2020 1:46 pm
Topic starter
Cheers, I'll order the same stepper motor and let you know how mine runs will hopefully have everything i need in the next couple of weeks.
Dave
Posted : 28/08/2020 8:29 am
I didn't have a pressure relief valve in my setup. I should have that and all of the fittings to plumb it by early next week. Then I will be ready to make a few power pulls and see how it reacts with my water control valve.
Posted : 03/09/2020 2:53 pm
Page 2 / 2
Prev