Q&A Forum

Notifications
Clear all

USB issue laptop

3 Posts
3 Users
0 Likes
1,444 Views
(@madswp)
Posts: 46
Member
Topic starter
 

Greetings everone!

When i do a power measurement with yourdyno combined with datalogging of ECU on the engine then i always get error on the datalog. It just pauses the datalog while dynoing and then continue logging when finished dynorun. both yourdyno and datalog connects with each their USB cable.

I am pretty sure its not the yourdyno tool that is the issue. But has anybody of you a solution for this? I am thinking of USB-settings on windows laptop that might need changing? Right now i use 2 laptops. but it will surely be nicer with only one

Cheers

 
Posted : 10/08/2019 2:37 pm
(@admin)
Posts: 1397
Member Admin
 

Hi, that's a strange issue! How does it look in the Device manager when both devices are connected? 

 
Posted : 10/08/2019 3:57 pm
(@bmgjet)
Posts: 362
Dyno Wizard
 

Iv ran into a simular issue where both YourDyno and the datalogging software I was using both use C# and ComPorts.
The datalogging software used a delay to control comport traffic flow which caused YourDyno to have micro pauses each time the delay was active in the other software.

 
Posted : 11/08/2019 1:32 am
Share:
Select your currency